Insulation fixings

Hammerset fixing for attaching ETICS insulation boards to concrete and masonry. It can also be screwed in, allowing the plate to be set flush or recessed.

Hammerset fixing with a steel-tipped compound nail for ETICS boards on concrete and masonry. The plate sits flush with insulation such as polystyrene or mineral wool.

Hammerset fixing with a glass-fibre-reinforced plastic nail for ETICS boards on concrete, solid masonry and hollow masonry. Designed for flush installation in insulation including polystyrene and mineral wool.

Screw fixing for attaching ETICS EPS and homogeneous mineral wool boards to concrete and masonry. A dedicated setting tool screws the plate into the insulation for recessed installation.

Screw fixing for attaching ETICS insulation boards to concrete, solid masonry and hollow masonry. Supports flush or recessed installation; recessed setting requires the TermoZ CS setting tool.

Pre-assembled screw fixing with a 110 mm plate for soft ETICS boards such as mineral wool. Designed for recessed installation on concrete and masonry using the CS setting tool.

Screw fixing for ETICS boards on wood and panel substrates, including OSB, MDF and gypsum fibreboard, without pre-drilling. The 6H setting tool supports flush or recessed installation.

Pre-assembled screw fixing with a polyamide plate for ETICS boards on wood and panel substrates. Installs flush without pre-drilling, with recessed installation possible in suitable insulation using the TSS setting tool.

Setting tools for recessing ETICS fixings into insulation. Each tool version is matched to a specific fixing type.

Replacement bits for ETICS setting tools: TX30 for CS and 6H, and TX25 for CNplus. Each version is matched to its respective setting tool.

Dedicated tool for removing TermoZ CNplus hammerset fixings and TermoZ CS II screw fixings when dismantling an ETICS façade.

Insulation caps for covering recesses above ETICS fixing plates. They are inserted by hand to create an even insulation surface before applying reinforced render.

MW and PS closing plugs for insulation openings left after installing TermoZ SV II EcoTwist in ETICS. They are pushed in by hand to finish flush with the insulation before reinforced render is applied.

Additional plates in 90, 110 and 140 mm diameters for compatible TermoZ, FIF and TermoFix fixings. Used for flush installation of ETICS boards with low compressive strength, such as soft mineral wool.